1. Barrel temperature. Pet molding temperature range is very narrow, the temperature directly affects the product performance. If the temperature is too low, it is not conducive to the manufacturing of plastic products, increasing the possibility of defects in injection molding parts; on the contrary, if the temperature is too high, it will cause overflow, discoloration, mechanical strength decline, or even degradation. Generally, the barrel temperature is controlled at 240 ~ 280 ℃, and the barrel temperature of glass fiber reinforced pet is 250 ~ 290 ℃. The temperature of the nozzle should not exceed 300 ℃, and the temperature of the nozzle is generally lower than that of the barrel.
2. Injection mold temperature. The temperature of injection mold has a direct effect on the cooling rate and crystallinity of the melt. The properties of plastic products are different with different crystallinity. The injection mold temperature is usually controlled at 100 ~ 140 ℃. The temperature of the injection mold should be controlled in a small range when the thin-walled plastic parts are formed, and the mold temperature should be higher when the thick wall plastic parts are formed.
3. Injection pressure. PET melt has good fluidity and is easy to form. The injection pressure of glass fiber reinforced pet is 90-150 MPa. The type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the type of injection molding machine, the location of injection molding machine, etc.
- 2007-08-27
Shunzhiying Mould participated in the A… - 2018-12-07
Our company has added new projects - 2018-12-07
What are the requirements for the desig… - 2018-08-08
What process can be used to change the … - 2018-12-07
Application of plastic injection mold i… - 2017-12-07
PEEK Injection Molding - 2019-06-06
What are the injection molding conditio…
管理员
该内容暂无评论